Morris · check your swing
How to hit a draw: start line, curve and control
By Morris Golf · Updated

Want Morris to look at your swing?
Ask MorrisFace and path: the two numbers behind a draw
TrackMan measures face angle and club path relative to the target line, with positive meaning right for every golfer. Face angle has the biggest influence on start direction, so a draw that starts right needs the face right of the target at impact. The path has to be in-to-out.
Face to path is face angle minus club path. With centred contact, the ball curves towards the face and away from the path. In a right-handed draw the path points further right than the face, so the value is negative: the face is closed to the path while still open to the target. Mixing up those two meanings of closed is an easy way to spoil a draw.
For a left-handed golfer everything mirrors: the draw starts left and curves right, so face and path are negative, the path further left, and face to path positive. Check the strike mark too, because off-centre contact changes the curve.
Build the shot without overdoing it
Start with the start line. Pick a line right of the flag, set up so the path can travel along it, and let the face close to that path only slightly. Chris Ryan's corpus lesson on the driver draw works on body alignment and the club's path at impact: the setup prepares the path, and face and path together make the shape.
A hook appears when the gap between face and path grows. A common route is exaggerating the in-to-out path: the ball would start well right, so the hands shut the face to save it. A coach quoted in TrackMan's club-path article describes the pattern: an extreme path forces the face to compensate, which brings excessive curve and an inconsistent flight. The fix is a smaller gap, not an even more inside downswing.
What Morris would check on video
From a down-the-line clip, the free analyzer estimates the hand path and the shaft angle at key positions, which helps show whether the club approaches from the inside. Each estimate carries a confidence level, and one 2D camera cannot measure club path or face angle at impact. Film from the same spot every time, behind the hands and square to the target line: a camera set off the line changes the apparent plane.
So Morris pairs the video with the ball flight. Describe where the ball starts and how it curves, or connect TrackMan on WhatsApp so Morris reads face angle, club path and face to path shot by shot. If the path is already well in-to-out and the face closes hard, the question for the video becomes what pushes the path out, not how to swing more from the inside.
Four driver sets, from fade to hook
Synthetic example: invented numbers to show the arithmetic. Not a real player and not a target.
| Set | Face angle (°) | Club path (°) | Face to path (°) | Ball flight |
|---|---|---|---|---|
| Usual shot | +1.0 | -2.0 | +3.0 | Starts a touch right, curves right |
| Path moved, face followed | +3.0 | +1.0 | +2.0 | Starts right, keeps curving right |
| Draw | +2.0 | +4.0 | -2.0 | Starts right, curves back to the target |
| Over-drawn | +1.0 | +7.0 | -6.0 | Starts right, hooks across the target line |
Moving the path alone did not create a draw, because the face moved right with it. The draw appeared once the path pointed further right than the face. The hook started on a similar line with a face-to-path gap three times larger: shrink the gap rather than repeat the move harder.
A start line first, then the curve
Practice proposal by Morris, informed by the reference topic; not an instructor transcript.
- 1
Mark the start line
On the range, choose a target and a start line a little to its right. Lay an alignment stick or a headcover a few paces ahead as a reference, well clear of the club's path.
- 2
Begin with half swings
With a mid-iron, start the ball along that line and let it curve back. Note the start line and curve of every ball; if you connect TrackMan, note face angle and club path as well.
- 3
Lengthen, keep the gap small
Make the swing longer only while the ball keeps starting on your line. If it begins to hook, return to half swings and aim for less curve rather than steering with the hands.
Self-check: It works when most balls start on your line and finish near the target with a curve you can predict. A big hook that sometimes finishes on target is not yet a draw you own.
Teacher reference
Chris Ryan Golf — How To Hit A Draw With The Driver
Morris wrote this explanation. The link credits the teaching topic; it does not imply the instructor endorses Morris or reproduce a transcript.
Apply it to your own game
A swing video and a description of your miss help turn a general idea into a specific check.
Sources
- Chris Ryan Golf — How To Hit A Draw With The Driver — Reference from the instruction corpus. Our own explanation; the Morris rehearsal is not a transcript of this video · Reviewed 20-11-2026.
- TrackMan — What is Face Angle? — Face angle has the biggest influence on start direction; a draw starts right, so the face must point right of the target · Reviewed 20-11-2026.
- TrackMan — What is Club Path? — An in-to-out path is needed for a draw; an extreme path forces face compensation and excessive curve · Reviewed 20-11-2026.
- TrackMan — What is Face-to-Path? — Face to path = face angle minus club path; with centred contact the ball curves towards the face and away from the path · Reviewed 20-11-2026.
Check your own swing for free
Drop a video of one swing here
One swing, face-on or down the line, your whole body in the frame. Up to 20 seconds.
Your video is used only for this analysis and is deleted after 30 days. No name, no email, no account.
Common questions
What is the difference between a draw and a hook?
Should I close the clubface at address to hit a draw?
Does a draw go further than a fade?
Can the free analyzer tell me my club path?

Your swing, through Morris's eyes
Send him a video on WhatsApp and he comes back with what he sees, the drill to do and how to check it.